Acoustic Research AWS73 Installation And Operation Manual page 3

Tour of the Speaker
900MHz Wireless Transmitter
Included Accessories
3.5mm audio in cable
Powering the Speaker System
Powering the Transmitter
Note:
There is no transmitter ON/OFF switch. The transmitter is designed to be left plugged
in and powered at all times. If you will not be using the AWS73 for an extended period of time,
unplug the transmitter AC power adapter.
Powering the Speaker
There are two options to power your wireless speaker: using the included AC power adapter
or using 6 AA batteries (not included).
(not shown)
Note:
Be sure to use the speaker AC power adapter rated 10V DC 1500 mA.
Warning:
environments, such as rain, mist, dew, etc. In other words, you can take it out, just don't leave
it out. If you plan to use the speaker in a humid or wet environment, we recommend powering
it with batteries instead of with the power adapter.
Top panel
CHANNEL DC IN
1 2 3
R AUDIO L
IN
Back panel
Connect the small, round plug from the transmitter AC
power adapter to the transmitter's DC IN jack. Plug the
other end of the transmitter AC power adapter into any
standard 120V AC wall outlet.
Note:
rated 12V DC 200 mA (it has the smaller diameter plug).
AC Power Adapters
1.
2. Plug the other end of the speaker AC power
This product is water-resistant, not waterproof. Avoid prolonged exposure to wet
SIGNAL
indicator lights green when the audio is
present and the transmitter is broadcasting.
POWER
indicator lights when the transmitter is
on.
CHANNEL 1 2 3
lets you fi nd the best
transmission frequency for your environment.
DC IN
jack receives the small round end of the
included 12V 200mA AC power adapter.
AUDIO IN (R / L)
connects to your sound source
using one of the connection options shown here.
Note: These power units should be plugged in so
that they stay vertical or lie fl at.
Be sure to use the speaker AC power adapter
Insert the small, round plug from the speaker AC
power adapter into the DC IN jack on the bottom
of the speaker.
adapter into any standard 120V AC wall outlet.
Powering th
AA Batteries
1. Remove the battery compartme
2. Insert six (6) AA batteries (not i
("+" and "-") as diagrammed ins
3. Replace the battery compartme
Note:
Place the rubber cap in the
DO NOT
mix batteries with different
DO NOT
battery). mix new and used
when not in use for long periods. Alw
recycle or dispose of them in accorda
Setting Up F
Connecting to an Au
Connecting to an A/V Receiv
Connecting to a Portable Aud
Adjusting the Trans
1. Turn on your audio source (for e
music at a normal listening volu
2. Se
Channel
select
switch
CHANNEL
DC IN
1 2 3
R AUDIO L
IN
Note
If the SIGNAL indicator on the tran
- Confi rm the transmitter AC
- Confi rm the cable from the
output (MP3 player, A/V rec
- Confi rm the audio source is
on
If
a d
an
W
th