Specification; Troubleshooting - VIETA HMD400 User Manual

SPECIFICATION

DISC TYPE
VIDEO TYPE
AUDIOTYPE
SIGNAL OUTPUT
INPUT
OUTPUT
POWER REQUIERMENTS
POWER CONCUMPTION
FREQUENCE RESPONSE
S/N
TEMPERATURE
Note:The product specifications may be subject to change,and no additional notices will be given.

TROUBLESHOOTING

Before calling for service, you can perform the checks described in the troubleshooting guide for immediate solutions.
PROBLEM
Unit can not be turned on
Remote control doesn't work
No picture
Disc cannot be played
No sound
Poor picture quality and audio
Display correctly but no response
Without response
DVD /VCD1.0 1.1 2.0/CD-DA/MP3
DVD(MPEG2),VCD(MPEG1), MPEG4, DIVX 6
MPEG1,MPEG2,PCM,STEREO
VIDEO TYPE:NTSC or PAL
VIDEO SIGNAL:1.0 Vp-p
AUDIO:Mixed stereo,2V(RMS)
AUDIO IN
THREE BASE COLOR OUTPUT
S-VIDEO
VIDEO OUTPUT
CABLE
AC230V/50Hz
405W
20Hz~20KHz ±3dB
≥81dB A WIEGHTED
5℃~35℃
POSSIBLE REASON
the power plug is not plugged in
properly or is damaged
no battery or batteries are off
the remote conrtol used is out of
perational range
unit was not connected roperly
unit was not set up properly
disc error
loader doesn't close tray
no disc in tray
unit not coonected properly
Volume to low
disc dirty
disc scratched
disc warped
operation is wrong
main unit is jammed
20
TREATMENT
try plugging in again
Replace batteries
use it with right range
connet again
check setup instructions
lable side should be up r
eload disc in tray
put disc in tray
connect it again
adjust volume
clean the disc
replace disc
renew operation
reset