VIETA VPC350R Owner's Manual page 7

4. WIRING DIAGRAM (20 PIN + ISO + SMALL CONNECTORS)
FUSE
20-PIN
AUDIO/POWER
HARNESS
(See Figure 1)
7 8 7 8
5 6 5 6
3 4 3 4
1 2 1 2
Figure 1
ISO CONNECTOR 4 PIN+8 PIN
FEMALE WITH MALE TERMINAL
ISO CONNECTOR WIRING CHART
FUNCTION/LABEL
PIN WIRE COLOR
A4 YELLOW BATTERY(+)
A5 POWER ANTENNA
BLUE
IGNITION(ACC)
A7 RED
GROUND
A8 BLACK
RIGHT REAR SPEAKER (+)
B1
VIOLET
RIGHT REAR SPEAKER (-)
B2 VIOLET/BLACK
RIGHT FRONT SPEAKER (+)
B3 GREY
RIGHT FRONT SPEAKER (-)
B4
GREY/BLACK
LEFT FRONT SPEAKER (+)
B5 WHITE
LEFT FRONT SPEAKER (-)
B6 WHITE/BLACK
LEFT REAR SPEAKER (+)
B7
GREEN
LEFT REAR SPEAKER (-)
B8 GREEN/BLACK
WHITE
AUX IN
RED
WHITE
REAR LINE OUT
GREY
RED
WARNING Connecting the ISO Connector
The pin arrangement for the ISO connectors depends on the type of vehicle you
drive.Make sure to make the proper connections to prevent damage to the unit.
The default connection for the wiring harness is described in
connector pins are set as described in
1
(Default setting) The 1 pin (red) of the vehicle's ISO connector is linked with
the ignition,and the 3 pin (yellow) is connected to the constant power supply.
ISO
CONNECTOR
(See Figure 1)
2 The 1 pin (red) of the vehicle's ISO connector is connected to the constant power
supply, and the 3 pin (yellow) is linked to the ignition.
3 The 3 pin (yellow) of the vehicle's ISO connector is not connected to anything,
while the 1 pin (red) is connected to the constant power supply (or both the 1(red)
and 3(yellow)pins are connected to the constant power supply).
When the connection is made as in
ignition key. For that reason,always make sure to turn off the unit's power when the
ignition is turned off.
To link the unit's power to the ignition,connect the ignition cable (ACC...red) to a
power source that can be turned on and off with the ignition key.
BR - 5
ANTENNA SHOCKET
YELLOW
RCA-TO-RCA CABLES
(not supplied)
Unit
Ignition wire
(RED)
Battery wire
(YELLOW)
Unit
Ignition wire
(RED)
Battery wire
(YELLOW)
Unit
Ignition wire
(RED)
Battery wire
(YELLOW)
3 above,the unit's power will not be linked to the
ANTENNA
JACK
AMP
1 below. If the ISO
2 or 3 .make the connection as illustrated.
Vehicle
1 PIN (RED)
3 PIN(YELLOW)
Vehicle
1 PIN (RED)
3 PIN(YELLOW)
Vehicle
1 PIN (RED)
3 PIN(YELLOW)