Installation Of Batteries In The Remote Control - VIETA VBR500 Owner's Manual

Installation of Batteries in the Remote Control

Install the batteries (AAA x 2) matching the polarity indicated inside battery compartment of the
remote control.
1. Open the cover.
2. Insert batteries.
Make sure to match + and - on the batteries to the marks indicated in the battery
compartment.
3. Close the cover.
Note:
Incorrect use of batteries can result in hazards such as leakage and bursting. Please observe
the following:
* Do not mix new and old batteries together.
* Do not use different kinds of batteries together. Although they may look similar, different
batteries may have different voltages.
* Make sure that the + and - ends of each battery match the indications in the battery
compartment.
* Remove batteries from battery compartment that is not going to be used for a month or more.
* When disposing of used batteries, please comply with governmental regulations or
environmental public instruction's rules that apply in your country or area.
* Do not recharge, short-circuit, heat, burn or disassemble batteries.
* The batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
BDP600_draft_30 Oct 09.indd 8
8
2009-11-2 17:19:00