Operating Sequence - Zanussi ZWF 1220 User Manual

Operating sequence

Before the first wash we recommend that you pour 2
litres of water into the main wash compartment of the
detergent drawer in order to activate the ECO valve.
Then run a cotton cycle at 95°C, with the machine
empty, in order to remove any manufacturing residue
from the drum and tub. Pour half a measure of
detergent into the main wash compartment and start
up the machine.
1. Place the laundry in the drum
Open the door.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible.
Close the door.
2. Measure out the detergent
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent recommended by the
manufacturer in a graduated cup and pour it into the
main wash compartment
If you have selected the prewash
detergent into the appropriate compartment marked
.
3. Measure out the additive
If required, pour fabric softener into the compartment
marked , without exceeding the «MAX» mark.
.
function, pour
4. Switch the machine on
Press the ON/OFF button
on. The display will show three blinking dashes or a
blinking zero. The light above the button will light up.
5. Select the desired programme/fabric
Press the FABRIC button
select the desired programme/fabric. The relevant
light will light up.
The lights relevant to the phases that form the
programme will light up.
The display will show the duration of the selected
programme, calculated on the basis of the maximum
load for each type of fabric. The START/PAUSE
button light will start flashing.
If the load of laundry to be washed is small, at the
beginning of the cycle the display will still indicate the
duration relevant to the maximum load. The duration
value will be gradually adjusted during the execution
of the cycle.
6. Select the temperature
Press the TEMPERATURE button
select a temperature value different from the one
proposed by the washing machine.
The relevant light will light up.
87
to switch the machine
repeatedly, in order to
if you wish to