Operating Sequence - Zanussi ZWH7100C User Manual

126.2936.41.qxd 31/10/08

Operating sequence

as much as possible. Close the door.
2. Measure out the detergent and the fabric
softener
Pull out the dispenser drawer until it stops.
Measure out the amount of detergent
required, pour it into the main wash
compartment
a programme with the prewash phase, pour it
into the compartment marked
If required, pour fabric softener into the
compartment marked
must not exceed the «MAX» mark in the
drawer). Close the drawer gently.
3. Select the required programme
The selector dial is divided into following sections:
Cottons,
●
Synthetics,
●
Special
●
The green Start/Pause light starts to flash.
38
14:40 Página 38
1. Load the laundry
Open the door by
carefully pulling the
door handle outwards.
Place the laundry in
the drum, one item at a
time, shaking them out
and, if you wish to carry out
.
(the amount used
The selector dial can be turned either
clockwise or anticlockwise.
Position «Off» to Reset programme/Switching
OFF of the machine.
At the end of the programme the selector
dial must be turned to position «Off», to
switch the machine off.
IMPORTANT!
If you turn the programme selector dial to another
programme when the machine is working, the
red Start/Pause pilot light will flash 3 times to
indicate a wrong selection. The machine will not
perform the new selected programme.
4. Select the spin speed or No spin or
Rinse Hold option
Press the Spin button
repeatedly to change
the spin speed, if you
want your laundry to
be spun at a speed
different from the one
proposed by the
appliance.
The relevant light will
light up.
Maximum speeds are:
Cottons: 1000 or 1200 rpm, depending on
●
the model;
Synthetics, Handwash and Sport 40°: 900 rpm
●
Delicates: 700 rpm;
●
No spin : By selecting this option, all
spinning phases are suppresed. On Cotton,
Synthetic and Delicates programmes, the rinses
will be performed with more water.
Rinse Hold (Agua en cuba): by selecting this
option the water of the last rinse is not emptied
out to prevent the fabrics from creasing. When
the programme has finished the pilot lights
«Door» and «End» are lit, the Start/Pause and
«Wash» lights are off and the door is locked to
indicate that the water must be emptied out.