Installation; Unpacking; Positioning; Water Inlet - Zanussi ZWF 1220 User Manual

Installation

Unpacking

All transit bolts and packing must be removed
before using the appliance.
You are advised to keep all transit devices so
that they can be refitted if the machine ever has
to be transported again.
1. After removing all the packaging, carefully lay
machine on it's back to remove the polystyrene
base from the bottom.
2. Remove the power supply cable and the draining
hose from the hose holders on the rear of the
appliance.
3. With a suitable spanner unscrew and remove the
central rear bolt A. Slide out the relevant plastic
spacer.
4. Unscrew and remove the two large rear bolts B
and the six smaller bolts C.
5. Remove the bracket D and tighten up the six
smaller bolts C.
D
6. Open the porthole, take out the inlet hose from
the drum and remove the polystyrene block fitted
with the adhesive tape on the door seal.
7. Fill the smaller upper hole and the two large ones
8. Connect the inlet hose as described under the

Positioning

Install the machine on a flat hard floor.
Make sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that the
machine does not touch the wall or other kitchen
units.
Carefully level by screwing the adjustable feet in or
out. Never place cardboard, wood or similar
materials under the machine to compensate for any
unevenness in the floor.
C
B
B
C

Water inlet

An inlet hose is supplied and can been found inside
the machine drum.
Do not use the hose from your previous machine
to connect to the water supply.
1. Open the porthole and extract the inlet hose .
2. Connect the hose with the angled connection to
C
Important!
Do not place the inlet hose downwards. Angle
the hose to the left or right depending on the
C
position of your water tap.
77
with the corresponding plastic plug caps supplied
in the bag containing the instruction booklet.
paragraph "Water Inlet".
the machine.