Ant/Cable/Satellite (If Available) - Toshiba TL969 Digital Series Owner's Manual

SETTING UP YOUR TV
v
If your satellite dish is movable, the following
Positioning screen will appear.
Positioning
Satellite : ASTRA 19.2°E
Transponder
Go to 0
Go to Stored Position
Step Size
Positioning
Signal Level
B b
Press or to highlight Positioning, and then press
C c
or to find the dish position with the strongest
signal level.
B b
Press or to highlight Store Position and press
OK to store the dish position. Repeat steps 21 and 22
for the next satellite as necessary.
If your satellite dish is not movable, the Positioning
screen will not appear.
Adjust the dish position manually for the maximum
Signal Level strength. The signal level strength is
displayed from 0% to 100%. A high signal level can be
achieved by adjusting the satellite dish the best way
possible.
Signal Level
Highlight Done and press OK.
w
If the reception testing completes successfully, the
Auto Tuning startup screen will display.
Auto Tuning - Satellite
Satellite
Search Option
You can select Search Option from Free to Air and
All.
When choosing the search option All, all channels
(including encrypted ones) of the satellite will be
searched for. If you wish to only search for
unencrypted (free) channels, please select Free to
Air. In this case, the channel scan will be completed
faster.
1/83 (10743 MHz H)
1
W E
Store Position
Start Scan
ASTRA 19.2°E
Free to Air
x
B
Press or
OK.
The television will start to search for available DVB-S
channels. The progress bar will indicate the scan
status.
When the search is complete, the Auto Tuning results
screen will display the total number of services found.
y
B
Use or
channel, and then press OK to view.
PLEASE NOTE
30%
The Quick Setup menu can also be accessed at any
time from the SETUP menu.

Ant/Cable/Satellite (if available)

From this menu, you can set the RF input configuration.
a
Press MENU /
b
B
Press /
press OK.
c
b
Press to select Ant/Cable/Satellite and press
c
to select Antenna, Cable or Satellite.
NOTE: When you attempt to change the Ant/Cable/
Satellite setting, a warning message will appear
followed by PIN entry (if PIN has been set) and a
30%
prompt for Auto Tuning.
20
b
to highlight Start Scan, and then press
b
to move through the list to select a
C c
to highlight Setup icon.
C c
to highlight System Setup icon and
C
or