Table of Contents
Advertisement
To conserve energy it is best to turn your TV off and not to leave it in Standby, unless the timer has been set.
Connect the aerial to the socket on the rear of the television. If you use a Set Top Box and/or a video recorder it is essential that the
aerial cable is connected through the Set Top Box and/or through the video recorder to the television.
DO NOT CONNECT SCART LEADS UNTIL THE TELEVISION IS FULLY TUNED.
☛
Aerial
GREEN = On Timer is set
ORANGE = Dual language
being received
GREEN = Stereo signal being received
Connecting and turning on
your new TV
The TV back connections...
*
SET TOP BOX
IN
OUT
Aerial Cable
...and switching your new TV on...
RED = Power On
unattended for short periods of time. To
return to TV mode press the
or any of the numbered buttons on the
remote control. The picture may take
SETTING UP
COMPONENT
COMPONENT
VIDEO INPUT
VIDEO INPUT
Y
Y
P
P
/C
/C
B
B
B
B
P
P
/C
/C
R
R
R
R
(AUDIO/VIDEO) (AUDIO/VIDEO)
(AUDIO/VIDEO) (AUDIO/VIDEO)
Video Recorder
IN
OUT
Aerial Cable
On the front of the TV...
If the red power-on light is unlit, press the POWER button on the front of
the TV to switch the set on and then press a number button on the remote
control to see the screen.
...and with the remote control:
Press the Standby Button
This allows you to put the set into
standby mode when leaving the TV
i
a few seconds to appear.
5
AUDIO
AUDIO
i
:
button,
To conserve energy, do not leave the
set in Standby for long periods of time.
Advertisement
Table of Contents
