Direct Tuning; Automatic Tuning - Sony ST-RDB940 Operating Instructions Manual

Fm stereo fm-am receiver
Hide thumbs Also See for ST-RDB940:
Table of Contents

Advertisement

Direct Tuning

Use the supplied remote to perform the following
operations. For details on the buttons used in this section,
see the operating instructions for the supplied remote.
1
Rotate FUNCTION to select the tuner.
The last received station is tuned in.
2
Press FM/AM to select the FM or AM band.
3
Press D. TUNING.
4
Press the numeric buttons to enter the frequency.
Example 1: FM 102.50 MHz
1
b
0
Example 2: AM 1350 kHz
(You don't have to enter the last "0" when the tuning scale is
set to 10 kHz.)
b
1
3
If you cannot tune in a station and the
entered numbers flash
Make sure you've entered the right frequency. If not,
repeat Steps 3 and 4.
If the entered numbers still flash, the frequency is not
used in your area.
5
If you've tuned in an AM station, adjust the
direction of the AM loop antenna for optimum
reception.
6
Repeat Steps 2 to 5 to receive another station.
z
If you try to enter a frequency that is too precise for the
tuning scale
The entered value is automatically rounded up or down.
The tuning scale for direct tuning differs depending on the area
code as shown in the following table. For details on area codes,
see page 3.
Area code
FM tuning scale
U, CA
50 kHz
AU, CN, SP, CED 50 kHz
* To change the AM tuning scale, see page 60.
b
2
b
5
b
0
b
b
5
0
AM tuning scale
10 kHz
(can be changed to 9 kHz)*
9 kHz

Automatic Tuning

For details on the buttons used in this section, see "Brief
descriptions of buttons used to receive broadcasts" on
page 44.
1
Rotate FUNCTION to select the tuner.
The last received station is tuned in.
2
Press FM/AM to select the FM or AM band.
3
Press TUNING (PTY SELECT) + or TUNING (PTY
SELECT) –.
Press the + button to scan from low to high; press the –
button to scan from high to low.
The receiver stops scanning whenever a station is
received.
When the receiver reaches either end of the
band
Scanning is repeated in the same direction.
4
To continue scanning, press TUNING (PTY SELECT) +
or TUNING (PTY SELECT) – again.
45

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Str-db840

Table of Contents