Table of Contents
Advertisement
Receiving Broadcasts
Before receiving broadcasts, make sure you
have connected FM and AM antennas to the
receiver (page 7).
Direct tuning
You can enter a frequency of the station you
want directly by using the numeric buttons on the
supplied remote. For details on the buttons used
in this section, see pages 34–37.
1
Turn INPUT SELECTOR to select the
FM or AM band.
The last received station is tuned in.
2
Press D.TUNING on the remote.
3
Press the numeric buttons to enter
the frequency.
Example 1: FM 102.50 MHz
b
b
1
0
2
Example 2: AM 1350 kHz
b
b
1
3
If you cannot tune in a station and
the entered numbers flash
Make sure you've entered the right
frequency. If not, repeat steps 2 and 3.
If the entered numbers still flash, the
frequency is not used in your area.
b
b
5
0
b
5
0
4
If you've tuned in an AM station, adjust
the direction of the AM loop antenna for
optimum reception.
5
Repeat steps 1 to 4 to receive another
station.
Tips
• If you do not remember the precise frequency, press
TUNING + or TUNING – after entering the value
close to the frequency you want. The receiver
automatically tunes in the station you want. If the
frequency seems to be higher than the entered value,
press TUNING +, and if the frequency seems to be
lower than the entered value, press TUNING –.
• If "STEREO" flashes in the display and the FM
stereo reception is poor, press FM MODE to change
to monaural (MONO). You will not be able to enjoy
the stereo effect, but the sound will be less distorted.
To return to stereo mode, press FM MODE again.
The tuning scale is:
FM: 50 kHz
AM: 9 kHz
Automatic tuning
If you don't know the frequency of the station
you want, you can let the receiver scan all
available stations in your area.
1
Turn INPUT SELECTOR to select the
FM or AM band.
The last received station is tuned in.
2
Press TUNING + or TUNING –.
Press TUNING + to scan from low to high;
press TUNING – to scan from high to low.
The receiver stops scanning whenever a
station is received.
When the receiver reaches either end of
the band
Scanning is repeated in the same direction.
3
To continue scanning, press TUNING +
or TUNING – again.
GB
29
Advertisement
Chapters
Table of Contents
