TOHATSU 5 BS Owner's Handbook Manual page 24

Outboard motor
Hide thumbs Also See for 5 BS:
Table of Contents

Advertisement

(III) OUT-OF-SEASON
STORAGE
The off-season gives you a good opportunity
to have
your
TOHATSU
serviced
or
overhauled
by your
dealer.
Not only will the motor be better preserved in
storage, but it will also be ready for immediate
use as
soon as the new season opens.
Storaging
procedures
are as follows:-
1) Wash outboard
motor
externally
and flush cooling
system completely
with fresh water.
Dry and wipe over with an oily rag.
2) Drain
fuel from tank, pipe lines, fuel pump
and
carburetor
and
clean
them
with
air blast.
To
prevent
internal
rusting
of the separate fuel tank
while
out of service, add a little 2 cycle engine oil
and
turn
the
tank
over so that
it covers all
surfacer.
or completely
fill the
tank
with
fuel
which
has a greater
than
normal
ratio
of oil.
(M5BS)
3) Ask your dealer to clean carbon
beposit on cylin-
der head, piston.
exhaust port and manifold.
Add
2 cycle engine oil through
the spark plug hole and
inject
oil into
crank case and cylinder
from the
carburetor
and turn the engine a few times by turn-
ing the recoil starter.
4) Apply grease to the propeller
shaft.
22
5) Change the gearcase oil.
6) Apply grease to all sliding parts. mechanical
joints,
bolts, nuts, etc.
7) Store the outboard
motor
on a stand in a vertical
position
in a dry place covered by a sheet.
9) When a outboard
motor is going to be reused after
long period store.
@) Run a engine with slow speed for 5 minutes.
Q Run a engine with half throttle
for 10 minutes.
These are for cleaning
of fitting
engine oil inside of
engine that was changed in quality.
1: lowered
performance
by storing long
period).
9) For daily using outboard
motor.
Be sure to carry warming-up
engine for at least 3
minutes to supply engine oil on required
position.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

M5bM5bs5 b

Table of Contents