TOHATSU 5 BS Owner's Handbook Manual page 21

2. AFTER COMPLETING DAY'S RUNNING
(1) When removing motor from boat
1) Completely drain water from engine before laying
it on rhe ground.
2) When you lay the motor onto the ground. make
sure that the drive unit is lower than the power
head to drain water. Otherwise, if the power head
is lower there is the danger of water entering the
cylinder.
3) When you lay the motor onto the ground, make
sure that the barhandle side is upwards
Caution: Do not lay the motor on the shift lever
side or front side facing to the ground.
(Fig. 26)
I)
A \
\
Fig. 26
(2) After use in salt or polluted water
1) Wash all external surfaces with fresh water, dry
and wipe with an oily rag. Oil all sliding parts.
2)
To wash out the cooling system first remove the
propeller and place the unit vertically in a large
bucket or tank containing more than 40cms
Idepth) of fresh water. Start the engine and allow
to run at a lcw speed so that the fresh water
flushes out the cooling system.
Remove the water plug on the Drive Shaft Housing
and screw the flushing plug.
Connect a hose to this adaptor and flush out the
system with fresh water. (Fig. 27)
3) The carburetor and magnero have been carefully
adjusted at the factory to give the best results, and
therefore should not be touched.
If any adiustment is needed please contact your
local TOHATSU dealer for information and assit-
awe.
19