Operation - Ryobi LCDI1402 Owner's Operating Manual

SPECIfICATIONS
BATTERy
MODEL PACK
(not included)
130224024
130111073
BPP-1413
LCDI1402 BPP-1415
BPP-1417
BPL1414

OPERATION

WARNING
Do not allow familiarity with products to make
you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING
Always wear safety goggles or safety glasses
with side shields when operating products.
Failure to do so could result in objects being
thrown into your eyes, resulting in possible
serious injury.
WARNING
Do not use any attachments or accessories
not recommended by the manufacturer of this
product. The use of attachments or accessories
not recommended can result in serious personal
injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Drilling in all types of wood products (lumber,
plywood, panelling, composition board, and hard
board)
 Drilling in ceramics, plastics, fiberglass, and laminates
 Drilling in metals
 Driving screws
 Hammer drilling in brick, or other masonry
English
This product will accept RYOBI 14.4 V lithium-ion battery
packs and RYOBI 14.4 V nickel-cadmium battery packs.
COMPATIBLE
BATTERy PROTECTION fEATURES
CHARGER
RYOBI 14.4 V lithium-ion batteries are designed with
(not included)
features that protect the lithium-ion cells and maximise
140262011
battery life. Under some operating conditions, these
140289013
built-in features may cause the battery and the tool it is
powering to act differently from nickel-cadmium batteries.
140217023
During some applications, the battery electronics may
140268007
signal the battery to shut down, and cause the tool to
140427003
stop running. To reset the battery and tool, release the
140111074
trigger and resume normal operation.
140268008
NOTE: To prevent further shut down of the battery, avoid
BCL1418
forcing the tool.
If releasing the trigger does not reset the battery and
BCL1418
tool, the battery pack is depleted. If depleted, the battery
pack will begin charging when placed on the lithium-ion
charger.
TO INSTALL BATTERy PACK
See Figure 2.
 Lock the trigger switch by placing the rotation selector
 Place the battery pack on the tool.
 Make sure the latches on each side of the battery
TO REMOVE BATTERy PACK
See Figure 2.
 Lock the trigger switch by placing the rotation selector
 Depress the latches on the side of battery pack.
 Remove the battery pack from the tool.
3
in the center position.
pack snap into place and the battery pack is secured
on the tool before beginning operation.
WARNING
Always remove battery pack from your tool when
you are assembling parts, making adjustments,
cleaning, or when not in use. Removing battery
pack will prevent accidental starting that could
cause serious personal injury.
in the center position.
WARNING
Battery tools are always in operating condition.
Therefore, the switch should always be locked
when not in use or carrying at your side.