Ryobi LCDI1802 Owner's Operating Manual
Ryobi LCDI1802 Owner's Operating Manual

Ryobi LCDI1802 Owner's Operating Manual

18 volt compact hammer drill driver
Hide thumbs Also See for LCDI1802:

Advertisement

LCDI1802
18 VOLT COMPACT HAMMER DRILL DRIVER
OWNER'S OPERATING MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LCDI1802 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Ryobi LCDI1802

  • Page 1 LCDI1802 18 VOLT COMPACT HAMMER DRILL DRIVER OWNER’S OPERATING MANUAL...
  • Page 2 DESCRIPTION Keyless chuck 22. Lock (tighten) Torque adjustment ring 23. Unlock (release) Quick mode selector 24. Low speed Two-speed gear train 25. High speed 5 . Rotation selector (forward/reverse/center lock) 26. Drive mode Depth rod stop 27. Drill mode Bit storage 28.
  • Page 3 Fig. 4 Fig. 2 Fig. 5 Fig. 3 Fig. 6...
  • Page 4 Fig. 7 Fig. 8 Fig. 9 Fig. 10...
  • Page 5 Important! It is essential that you read the instructions in this manual before operating this machine. Subject to technical modifications.
  • Page 6 English GENERAL POWER TOOL SAFETY WARNINGS Do not use a power tool while you are tired or under the influence of drugs, alcohol or medi- cation. A moment of inattention while operating WARNING power tools may result in serious personal injury. Read all safety warnings and all instructions.
  • Page 7: Drill Driver Safety Warnings

    English power tools operation. If damaged, have the  Wear ear protectors. Exposure to noise can cause power tool repaired before use. Many accidents hearing loss. are caused by poorly maintained power tools.  Use auxiliary handle(s), if supplied with the tool. Keep cutting tools sharp and clean.
  • Page 8: Operation

    49 Nm  Hammer drilling in brick, or other masonry Weight (not incl. battery pack) 1.68 Kg This product will accept RYOBI One+ 18 V lithium-ion battery packs and RYOBI One+ 18 V nickel-cadmium Compatible battery Compatible charger battery packs.
  • Page 9 English Therefore, the switch should always be locked when not in use or carrying at your side. KEYLESS CHUCK See Figure 5. TRIGGER SWITCH The drill has a keyless chuck to tighten or release drill See Figure 4. bits in the chuck jaws. The arrows on the chuck indicate which direction to rotate the chuck body in order to LOCK ...
  • Page 10 English 1. APPLICATION 2. SPEED 3. MODE • Lag screws up to 9.5 mm dia. by 38.1 mm long 1/LOW DRILL MODE • Hole saw up to 50.8 mm (TORQUE ADJUSMENT NOT ACTIVE) • Spade bits up to 38.1 mm •...
  • Page 11: Installing Bits

    REMOVING BITS See Figure 9. WARNING  Lock the trigger switch by placing the rotation selector When servicing, use only identical RYOBI in the center position. replacement parts. Use of any other parts may  Open the chuck jaws. create a hazard or cause product damage.
  • Page 12: Environmental Protection

    English WARNING Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. ENVIRONMENTAL PROTECTION Recycle raw materials instead of disposing a s w a s t e .

Table of Contents