Specifications; Standard Accessories; Operation - Ryobi EAG95100RG Owner's Operating Manual

ANGLE GRINDER SAFETY PRECAUTIONS
 Check that the speed marked on the grinding wheel
is equal to or greater than the rated speed of the tool.
 Ensure that the dimensions of the grinding wheel are
compatible with the tool and that the wheel fits the
spindle.
 Grinding wheels must be stored in a dry place.
 Do not store objects on top of the grinding wheels.
 Grinding wheels must not be used for any operation
other than grinding.
 Grinding wheels must be stored and handled with care
in accordance with the manufacturer's instruction.
 Inspect the grinding wheel before use to ensure that it
is not chipped or cracked. Chips or cracks can cause
the wheels to shatter, resulting in possible serious
injury.
 Ensure that the wheel is fitted in accordance with this
manual.
 Ensure that the grinding wheel is correctly mounted
and tightened before use and run the tool at no-
load speed for 30 seconds in a safe position. Stop
immediately if there is considerable vibration or if other
defects are detected. If this condition occurs, check
the tool to determine the cause.
 Do not use separate reducing bushings or adaptors to
adapt large hole grinding wheels.
 Check that the work piece is properly supported.
 Use only grinding wheels approved by RYOBI.
 Ensure that sparks resulting from use do not create
a hazard e.g. do not hit people, or ignite flammable
substances.
 Always use protective safety glasses and ear
protectors.
 Use other personal protective equipment such as
gloves, apron and helmet when necessary.
 Never place the tool on the floor or other surfaces
while it is running. Grinding wheels continue to rotate
after the tool is switched off. Never touch the wheel or
place it on the floor or other surfaces while it is rotating.
 The flange and clamp nut must have same outer
diameter.
 Use the tool only for approved applications. Never use
coolants or water or use the tool as a fixed tool.
 Grip the tool securely with both hands while operating.
English

SPECIFICATIONS

Model
Grinding wheel
diameter
Thickness
Voltage
Input
Spindle thread
Rated speed
Overall length
Net weight
NOTE: Be sure to check the nameplate on the product,
because the voltage is subject to change depending on
the area in which the product is to be used.
Maximum circumferential speed of grinding wheel: 4,800
m/min.
Example of calculation
3.14 x 125 x 11,000/1,000 =
Circumferential speed of
grinding wheel
Wheel diameter
Rated speed of grinder

STANDARD ACCESSORIES

Overmold handle, Wrench.
A grinding wheel is included in the standard accessories
for some countries.

OPERATION

See Figure 3.
Keep safety guards in place. Never cover the air vents
since they must always be open for proper motor
cooling.
The key to effi cient operating is controlling the pressure
and surface contact between the disc and work piece. Flat
surfaces are ground at an acute angle, usually 10 to 20
4
EAG95100RG EAG95125RG
100 mm (4 in) 125 mm (5 in)
6 mm 6 mm
240 V 50 Hz 240 V
950 W 950 W
M10 M14
11,000 min -1 11,000 min
310 mm 310 mm
2.45 kg 2.6 kg
4,320
4,320
125
11,000
WARNING
50 Hz
-1