Related Manuals for Ryobi EAG75100RG
Summary of Contents for Ryobi EAG75100RG
- Page 1 EAG75100RG / EAG75115RG ANGLE GRINDER OWNER’S OPERATING MANUAL EAG75100RG EAG75115RG...
- Page 2 7. Clamp nut 2. Tool-less wheel guard 8. Spindle shaft 3. Auxiliary handle 9. Wrench 4. Spindle lock button 10. Wheel guard lock lever 5. Switch 11. Live tool indicator 6. Disc fl ange EAG75100RG EAG75115RG Fig. 1 Fig. 2 Fig. 3...
- Page 3 Fig. 4 Fig. 5 90˚ 90˚ Fig. 6 Fig. 7...
- Page 4 Important! It is essential that you read the instructions in this manual before operating this machine. Subject to technical modifications.
-
Page 5: General Power Tool Safety Warnings
operating power tools may result in serious GENERAL POWER TOOL SAFETY WARNINGS personal injury. b. Use personal protective equipment. Always WARNING wear eye protection. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or Read all safety warnings and all instructions. Failure hearing protection used for appropriate conditions to follow the warnings and instructions may result in electric will reduce personal injuries. -
Page 6: Special Safety Rules
g. Use the power tool, accessories and tool bits can be attached to your power tool, it does not assure safe operation. etc., in accordance with these instructions and d. The rated speed of the accessory must be at in the manner intended for the particular type of power tool, taking into account the working least equal to the maximum speed marked on conditions and the work to be performed. -
Page 7: Kickback And Related Warnings
accessory has come to a complete stop. The on direction of the wheel’s movement at the point of pinching. Abrasive wheels may also break under these spinning accessory may grab the surface and pull conditions. the power tool out of your control. m. -
Page 8: Intended Use
Grip the tool securely with both hands while operating. WARNING SPECIFICATIONS Keep safety guards in place. Never cover the air vents since they must always be open for proper motor Model EAG75100RG EAG75115RG cooling. Grinding wheel 100 mm (4 in) 115 mm (4.5 in) diameter The key to effi... -
Page 9: Maintenance
After use, check the tool to make sure that it is in good condition. It is recommended that you take this tool to a Ryobi authorised service center for thorough cleaning and lubrication at least once a year. - Page 10 Techtronic Industries (Australia) Pty. Ltd. Level 1, 660 Doncaster Road Doncaster, VIC 3108, Australia Techtronic Industries New Zealand Ltd. 18-26 Amelia Earhart Avenue Mangere, Auckland 2022, New Zealand 20140116...