Maintenance - Ryobi EAG95100RG Owner's Operating Manual

degrees with the work piece. Allow the disc to reach full
speed before starting to grind. Too great an angle causes
concentration of pressure on a small area which may
gouge or burn work surface.
SWITCH
See Figure 2.
 This tool is started and stopped by sliding and releasing
the switch.
 For the convenience for continuous operation,
slide the switch along then press the front end down
to lock it.
 To release the lock, press the rear end of the switch.
MOUNTING THE GRINDING WHEEL
See Figure 4 - 5.
 Attach the disc flange and the wheel on the spindle
before fitting the clamp nut.
 Ensure that the wheel is correctly seated over the
boss on the disc flange and clamp nut with the flat side
facing up.
 Depress the lock button located on the right side of
gear case.
 Using the wrench provided, tighten the clamp nut in a
clockwise direction.
Check carefully whether or not there are cracks in the
wheel. Replace a cracked wheel immediately.
TOOL-LESS WHEEL GUARD
See Figure 6 - 7.
Release the wheel guard lock lever then turning the tool-
less wheel guard to the desired position. The max. turning
axie is 90° on either side; otherwise the guard can't be
locked.
LIVE TOOL INDICATOR
This tool features a live tool indicator which illuminates as
soon as the tool is connected to the supply. This warns the
user that the tool is connected and will operate when the
switch is pressed.

MAINTENANCE

After use, check the tool to make sure that it is in good
condition.
It is recommended that you take this tool to a Ryobi
authorised service center for a through cleaning and
lubrication at least once a year.
WARNING
English
Do not make any adjustments while the motor is in
motion.
Always disconnect the power cord from the socket
before changing removable or expendable parts
(grinding disc, cutting disc etc.), before lubricating or
working on the unit.
To ensure safety and reliability, all repairs should be
performed by an authorised service center or other
qualifi ed service organisation.
Save these instructions for future reference.
SYMBOL
Safety Alert
V Volts
Hz Hertz
Alternating Current
Watts
W
No-load speed
n
o
min -
1
Revolutions or reciprocations per minute
Conformity
Double insulation
Wear ear protection
Wear eye protection
Please read the instructions carefully before
starting the machine.
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
5
WARNING
WARNING