Safety tool. Do not use a power tool while you are GENERAL POWER TOOL SAFETY WARNINGS tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious WARNING personal injury. Read all safety warnings and all instructions.
Safety power tool repaired before use. Many accidents for cracks, tear or excess wear, wire brush are caused by poorly maintained power tools. for loose or cracked wires. If power tool or accessory is dropped, inspect for damage f) Keep cutting tools sharp and clean. Properly or install an undamaged accessory.
Safety be adequately protected. FURTHER SAFETY INSTRUCTIONS OPERATIONS c) The guard must be securely attached to the power tool and positioned for maximum safety, Kickback and related warnings so the least amount of wheel is exposed Kickback is a sudden reaction to a pinched or snagged towards the operator.
Page 6
30 seconds in a safe position. Stop ■ It is recommended that you take this tool to a Ryobi immediately if there is considerable vibration or if Authorized Service Center for a thorough cleaning and other defects are detected.
Page 7
Not for wet grinding. Using water or other liquid coolants may result in electrocution or shock. Wear safety hand gloves Regulatory Compliance Mark (RCM). Product meets applicable regulatory requirements. Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
PRODUCT SPECIFICATIONS Model EAG75125 Grinding wheel: Diameter 125 mm (5 in) Thickness 6 mm Rated voltage 220 V - 240 V 50/60 Hz Rated capacity 125 mm Input 750 W Spindle thread M 14 12000 min- 1 Rated speed Net weight...