HOW TO USE
This watch is an automatic watch equipped with a manual winding mechanism.
•
When the watch is worn on the wrist, the motion of the wearer's arm winds the
mainspring of the watch.
•
If your watch is completely stopped, it is recommended that you manually wind the
mainspring by turning the crown.
● How to manually wind the mainspring
1. Slowly turn the crown clockwise (the 1 o'clock
direction) to wind the mainspring.
* With manual winding, if you give the crown five full
rotations, it provides the power to run the watch for
approximately ten hours.
* Turning the crown counterclockwise (the 6 o'clock
direction) does not wind the mainspring.
. Wind the mainspring until the power reserve
indicator shows a fully-wound state. The sec-
ond hand will start moving.
* To check the winding state of the mainspring,
refer to "HOW TO READ THE POWER RESERVE
INDICATOR" on page 20.
* There is no need to turn the crown further when
the mainspring is fully wound. But the crown can
be turned without damaging the watch mechanism.
6