Preparation Before Use; Name Of Parts And Introduction Of The Temperature Control Panel - Siemens Refrigerator-freezer Operating Instructions Manual

1.4

Preparation before use

1.2
1 Unpack all of the components from the packing
material. Make sure that all of the foam packing
is removed. Unremoved foam packing is a fire
hazard.
2 Check that all of the components and
documents are present according to the packing
list.
3 Remove all adhesive tape from the inside of the
refrigerator and then clean with luke warm water
and dry and replace all attachments.
4 The refrigerator will take three hours to reach
the required temperature for storing food after it
has been switched on.
2.1
1.2
Before reading on, please check the
characteristics illustration. This
manual applies to various models.
Some of the illustrated details may
deviate from those present in your
model. Please check the packing
list for details.
1 - 8
12/21
Introduction of the temperature
control panel
Cooler temperature display button (1)
Normally the screen displays the temperature of
freezer. When this button is pressed, display will be
shifted to the current temperature of cooler. The
display switches again automatically to the
temperature of freezer after it is released more than
5 seconds.
Temperature selecting button of freezer (2)
This button is used to select the setting of the
freezer temperature between -18 °C and -26°C.
Page 7
Name of parts and introduction
of the temperature control panel
1
Figure
Control panel
9 Damper thermostat
10 Lamp
11 Glass shelf
Temperature sensor
13 Glass cover
14 Vegetable basket
15 Shallow tray
16 Short shallow tray (Egg tray)
17 Cover of short shallow tray
18 Deep tray
19 Berry basket
20 Freezer drawer
22 Freezer door
A Refrigerator compartment
B Freezer compartment
Figure 2
2006.7.18, 6:14 PM
GB
7