Servicing And Troubleshooting - Siemens Refrigerator-freezer Operating Instructions Manual

GB
3.2

Servicing and troubleshooting

Power cut
1 When a power cut occurs, the doors of the
refrigerator should be open as less as possible.
Avoid putting new food into the cooler or freezer
as this will cause the temperature to rise at a
faster rate.
2 If the power cut is known in advance, the quick
freezing function should be activated ( press
down " super" button) to reach a lower
temperature in the refrigerator. You can
also prepare some ice cubes and store them in
the upper section of the cooler during power cut
to keep the temperature in the cooler on a low
level.
Stop using
1 Switch off the refrigerator by directly
disconnecting the plug from the electrical supply.
2 If you have decided to cease using the
refrigerator for some time , please do as follows:
First switch off the refigerator, then clean inside
and leave the door open slightly to ventilate.
Note: Stopping use often will decrease the life
of the refrigerator.
Changing the lamps Figure
1 Disconnect the plug from the electrical supply.
2 Remove lamp shade (A), and unscrew the lamp
by turning in an anti-clockwise direction.
3 Replace with a new 25W / 220V /E14 lamp
and re-attach the lamp shade.
Note: Make sure that the correct lamp
output power is used.
14
Normal phenomena
1 Dew may appear on the exterior of the
refrigerator if the external humidity is high. This
can be wiped dry.
2 The area where the door seal sticks to the
refrigerator may be warm. This is caused by the
heating device to avoid dew and frost.
3 A bubbling / rattling noise sometimes could be
heard. This is due to refrigerant flowing in the
cooling pipe or because the refrigerator is in
start-up or closing mode.
4 The temperature of the compressor can reach
80°C.
10
Page 14
10
2006.7.18, 6:14 PM