Miele CS 1012 Product Dimensions page 3

Product and Cut-out Dimensions
CS 1012 Double Gas CombiSet CS 1012 Double Gas CombiSet
The illustration above represents the attachment of spring clips 1 and support bars 2 for 3
appliances
An additional support bar is required for each additional appliance. The position for the
attachment of an additional support bar depends on the width of appliance B.
Location Codes
1 – Spring Clips
2 2 – Support bars (Accessory, item - 27996029D CSZL 1500 (Includes cover 4)) Support bars (Accessory item 27996029D CSZL 1500 (Includes cover 4))
3 – Space between support bar and countertop
4 – Cover
Notes
All installations must be done in accordance with local codes.
Drawing is not to scale
p
Spring Clip installation
on wood or solid
surface countertop
Place the supplied Place the supplied
spring clips 1 and the
support bars 2 at the
marked positions as
shown above, by
laying them on the
upper edge of the cut-
out and then securing
them with the 1/8" x 1"
(3.5 x 25 mm) screws
(supplied)
p g p pp
Specification Sheets OJS 02212012
Page 3 of 4
Spring Clip installation
on a granite
countertop
Position and attach Position and attach
the spring clips 1 and
the support bars 2
with strong double-
sided tape 3
Coat the side and
lower edges of the
spring clips with p g p
silicone.
Fill the space between
the support bars and
the countertop with
silicon