Adjusting The Level Of Conductivity - Zanussi ZTE 225 Instruction Booklet

125981111 gb.qxp 2005-03-07

Adjusting the level of conductivity

Water contains, a variable quantity of limestone and
mineral salts of which quantities vary according to
geographical locations thus varying its conductivity
values.
Relevant variations of the conductivity of the water
compared to those prefixed by the factory could
slightly influence the residual humidity of the laundry
at the end of the cycle.
Your dryer allows you to regulate the sensitivity of
the drying sensor based on conductivity values of
the water by using the following procedure.
To access adjustment mode:
Turn the programme selector dial to switch on the
appliance. In selection mode, press simultaneously
the buttons 2 and 4.
IPress the buttons down until the pilot lights above
each ones begin to flash and one of the pilot lights
indicating the drying phase lights "DROGEN",
cooling "AFKOELEN", or end cycle "EINDE" remains
lit
Adjusting the level of conductivity:
Press the button Start/Pauze (Start/Pause)
sequentially: the level of conductivity is indicated by
the lighting of the horizontal hyphens.
08:39 Page 5
Conductivity
Display
degree
EINDE
Low
AFKOELEN
Medium
DROGEN
High
Normally, the appliance is factory-set to the
highest level; however, certain models may be
configured differently.
Memorizing the new setting:
Simultaneously press the buttons 2 and 4.
Press the buttons down until the pilot lights above
each ones stop flashing and the buzzer sounds.
5
Approximative
value (µS/cm)
< 300
300 - 600
> 600