Ryobi ECO2437 Owner's Operation Manual page 15

TROUBLESHOOTING
PROBLEM
Wheel does not cut through workpiece.
Machine vibrates or shakes excessively. 1. Wheel is out-of-round.
ENGLISH
CAUSE
1. Depth stop setting incorrect.
2. Wheel worn too much.
3. Incorrect cutting operation.
2. Wheel is chipped.
3. Wheel is loosen.
4. Machine is not secured.
5. Work surface is uneven.
10
SOLUTION
1. Adjust the depth stop. See "Depth
Stop" section.
2. Replace with a new 355mm (14")
abrasive cut off wheel.
3. See "Cut-Off" section.
1. Replace wheel.
2. Replace wheel.
3. Tighten wheel bolt on arbor.
4. Check and tighten all hardware.
5. Relocate and secure on a fl at
surface.