Troubleshooting - Ryobi ECO2437 Owner's Operation Manual

TROUBLESHOOTING

PROBLEM
Machine does not start
Motor does not reach full speed or
power.
Motor stalls, blows fuses, or trips
circuit breakers.
Motor overheats.
Machine is noisy when running.
Wheel hits table.
ENGLISH
CAUSE
1. Power cord not plugged in.
2. Power cord is damaged.
3. Circuit breaker is tripped.
4. Circuit fuse is blown.
5. Switch is damaged or burned out.
1. Voltage from power source is low.
2. Circuit is overloaded.
3. Motor burned out.
4. Fuses or circuit breakers are
wrong size.
5. Extension cord is too long.
6. Switch is defective.
1. Switch is defective.
2. Voltage from source is low.
3. Fuses or circuit breakers are
wrong size or defective.
1. Motor is overloaded.
2. Wheel is being fed into work too
fast.
1. Motor needs attention.
1. Wheel not properly installed.
2. Depth stop setting incorrect.
9
SOLUTION
1. Plug in cord.
2. Have the cord replaced at your
nearest authorized service centre.
3. Reset circuit breaker.
4. Replace circuit fuse.
5. Have the switch replaced at your
nearest authorized service centre.
1. Request a voltage check up.
2. Test on a different circuit or without
anything else on circuit.
3. Have tool serviced and request a
voltage check.
4. Have an electrician replace with a
wrong size. circuit breaker.
5. Use a shorter extension cord.
6. Have the switch replaced at your
nearest authorized service centre.
1. Have the switch replaced at your
nearest authorized service center.
2. Request a voltage check.
3. Have an electrician replace with a
circuit breaker.
1. Request a voltage check.
2. Feed wheel into work slower.
1. Have the motor checked at your
nearest authorized service centre
1. See "Removal and Installation of
Wheel" section.
2. Adjust the depth stop. See "Depth
Stop" section.