Specifications - Yamaha PCY10 Owner's Manual

Cymbal pad

Hide thumbs

page of 4

/ 4
Bookmarks

I Part Names

Pad

I Setting Up

G Using the PCY10 with the PCY60, 80,

65 Series Cymbal Pad (PCY60, 80/80S,

65/65S)

First, setup the rack system (Yamaha RS

Series, etc.) or a cymbal stand (Yamaha CS

Series, etc.) then use the supplied wing nut,

felt, etc., to attach the cymbal pad as shown

in the illustration.

The * denotes parts that are supplied with the PCY10.

To keep the PCY10 from rotating, position the

Stopper's shaft between the two ribs located

on the underside of the PCY10.

G Using the PCY10 alone

First, setup the rack system (Yamaha RS

Series, etc.) or a cymbal stand (Yamaha CS

Series, etc.) and attach in the same manner

as an acoustic cymbal.

I Specifications

Size

150mm (dia.) X 27mm (H) (Excluding the jack cable)

Weight

330g (Including the jack cable)

Sensor System

Trigger Sensor (Piezo) x 1

Output Jack

Standard Monaural Phone Jack

Accessories

Monaural PhoneCable (1.5m) x 1

Attachment Set x1 (Wing Nut, Felt(Large), Felt(Small), Cable Band, 1 each)

Owner's Manual (this booklet) x 1

*Improvements may result in a change in the specifications and/or design of the product without notice.

SPESIAL MESSAGE SECTION

NOTICE: Service charges incurred due to a lack of knowledge relathing to how a function or effect works (when the unit is operating as designed) are not covered by

the manufacturer's warranty, and are therefore the owners responsibility. Please study this manual carefuly and consult your dealer before requesting service.

ENVIRONMENTAL ISSUES: Yamaha strives to produce products that are both user safe and environmentally friendly. We sincerely believe that our products and the

production methods used to produce them, meet these goals. In keeping with both the letter and the spirit of the law, we want you to be aware of the following:

Battery Notice: This product MAY contain a small non-rechargeable battery which (if applicable) is soldered in place. The average life span of this type of battery is

approximately five years. When replacement becomes necessary, contact a qualified service representative to perform the replacement.

This product may also use "household" type batteries. Some of these may be rechargeable. Make sure that the battery being charged is a rechargeable type and that

the charger is intended for the battery being charged.

When installing batteries, do not mix batteries with new, or with batteries of a different type. Batteries MUST be installed correctly. Mismatches or incorrect installation

may result in overheating and battery case rupture.

Warning: Do not attempt to disassemble, or incinerate any battery. Keep all batteries away from children. Dispose of used batteries promptly and as regulated by the

laws in your area. Note: Check with any retailer of household type batteries in your area for battery disposal information.

Disposal Notice: Should this product become damaged beyond repair, or for some reason its useful life is considered to be at an end, please observe all local, state, and

federal regulations that relate to the disposal of products that contain lead, batteries, plastics, etc. If your dealer is unable to assist you, please contact Yamaha directly.

NAME PLATE LOCATIOIN: The name plate is located on the bottom of the product. The model number, serial number, power requirements, etc., are located on this plate.

You should record the model number, serial number, and the date of purchase in the spaces provided below and retain this manual as a permanent record of your purchase.

Model

Purchase Date

PLEASE KEEP THIS MANUAL

Jack Cable

Jack

* Wing Nut

PCY10

* Small Felt

* Large Felt

PCY60, 80, 65

Series Cymbal Pad

Felt