Screen Configuration; Setting The Day Of The Week And Time - Mitsubishi Electric Mr. Slim SEZ-KD09 Operation Manual

2. Parts Names
I Outdoor unit

3. Screen Configuration

Function Selection of remote controller
A
Standard Control Screens
OFF
B
Timer Monitor
MON
TIMER
OFF
˚F˚F
WEEKLY

4. Setting the Day of the Week and Time

TIME SUN
˚F
TEMP.
2 MENU ON/OFF
BACK MONITOR/SET DAY
PAR-21MAA CLOCK
A
Note:
G The day and time will not appear if clock use has been disabled at the Func-
tion Selection of remote controller.
G After the power supply returns, the indoor unit does not operate for three
minutes. Above operation is normal.
G If the setting 1 1 1 1 1 or 2 2 2 2 2 is set, the 12 hour clock (AM/PM) will be displayed.
1 1 1 1 1 CHANGE LANGUAGE setting = English [Refer to page 12]
2 2 2 2 2 Temperature display setting =
If the settings above are not set, the 24 hour clock (rail road time/military
time) will be displayed.
Only "Set Day/Time", "Standard Control Screens", "Timer Monitor" and
"Timer Set UP" screens are applicable to the settings.
4
KB79K741H01_en.pm6
Set Day/Time
TIME SUN
D C
˚F˚F
˚F
ON
C
Timer Setup
SUN MON TUE WED THU FRI SAT
B
WEEKLY
1
Day of the Week &
Time display
˚F
9
ON/OFF
FILTER 4
CHECK TEST
OPERATION CLEAR
°
F [Refer to page 12]
4
Power
Refrigerant
Pipes
Indoor-Outdoor
Connection wire
Ground
<Screen Types>
For details on setting the language for the remote controller display, refer
to Section 8: Function Selection.
The initial language setting is English.
G Function Selection of remote controller:
Set the functions and ranges available to the re-
mote controller (timer functions, operating restric-
tions, etc.)
G Set Day/Time:
Set the current day of the week or time.
G Standard Control Screens:
View and set the air conditioning system's oper-
ating status
G Timer Monitor:
View the currently set timer (weekly timer, sim-
ple timer, or Auto Off timer)
G Timer Setup:
Set the operation of any of the timers (weekly
timer, simple timer, or Auto Off timer).
<How to change the screen>
A : Hold down both the Mode button and the Timer On/Off button for 2
seconds.
B : Press the Timer Menu button.
C : Press the Mode (Return) button.
D : Press either of the Set Time buttons (
2
TIME SUN
1. Press the or Set Time button A to show display 2.
2. Press the Timer On/Off (Set Day) button 9 to set the day.
* Each press advances the day shown at 3 : Sun → Mon → ... → Fri →
Sat.
3. Press the appropriate Set Time button A as necessary to set the time.
* As you hold the button down, the time (at 4) will increment first in
minute intervals, then in ten-minute intervals, and then in one-hour in-
tervals.
4. After making the appropriate settings at Steps 2 and 3, press the Filter
button 4 to lock in the values.
Note:
G Your new entries at Steps 2 and 3 will be cancelled if you press the Mode
(Return) button 2 2 2 2 2 before pressing the Filter
5. Press the Mode (Return) button 2 to complete the setting procedure.
This will return the display to the standard control screen, where 1 will
now show the newly set day and time.
08.10.7, 9:33 AM
or ).
3
Day of the Week Setting
4
Time Setting
button 4 4 4 4 4 .