Rear Panel Connections - Harman Kardon HA160-0004-A Owner's Manual

Rear Panel Connections

IMPORTANT NOTE: Never make or remove any connections to the Signature 2.0 with the Master Power Switch in the
"ON" position. It is also a good practice to make certain that the power amplifiers connected to the 2.0 are also turned
off when making or removing any connections. This eliminates the risk of possible damage to your speakers or other
system components.
When making connections to the Signature 2.0 make certain that the plugs are firmly seated into the jacks. This prevents
intermittent connections which may interfere with performance.
a ·
FM AM
®
NRTL /C
LR110480
CSA E65
ANTENNA
FRONT CENTER SURR 1 2
L
R
SUB
6-CH DIRECT INPUTS 6-CH DIRECT INPUTS ANALOG AUDIO INPUTS ANALOG AUDIO INPUTS
¡ ™
¡ 6-CH Direct Inputs
™ Analog Audio Inputs
£ Record Outputs
¢ Main Channel Audio Outputs
∞ Subwoofer Output
§ RS-232 Control Port
¶ IR Input
¡ 6-CH Direct Inputs: Use these inputs for
connections to optional, external audio adapters. To
select a device connected to these jacks, the audio input
for a source must be changed to "6-CH Direct" using the
Source Menu (see figure OSD-6 on page 29).
™ Analog Audio Inputs: Connect the output of
analog audio devices to these inputs. Note the left
channel input is on top, and the right channel input is
on the bottom. Once the inputs have been connected
they may be assigned to any of the 2.0's seven source
positions using the Source Menu (see figure
OSD-6 on page 29).
Signature 2.0
° ‡
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
1 2 3 4 5 6
DIGITAL AUDIO DATA INPUTS
3 4 5 6 FRONT CENTER SURR
SUB SUB
REC OUTPUTS REC OUTPUTS AUDIO OUTPUTS AUDIO OUTPUTS
£ ¢ ∞
• IR Output
ª Trigger Output
‚ AC Power Cord
⁄ S-Video Record Output
¤ S-Video Main Output
‹ S-Video Inputs
› Composite Video Record Output
fl fi› ‹
IN
IN OUT
1
1 2 3
MAIN
4 5 6 2
REC
COMPOSITE VIDEO S – VIDEO
L
RS-232
IR
R
IN
Double Insulated – When servicing
use only identical replacement parts.
EXTERNAL CONTROLS EXTERNAL CONTROLS
§ ¶ • ª
fi Composite Video Main Output
fl Composite Video Inputs
‡ Optical Digital Audio Inputs
° Coax Digital Audio Inputs
· AM Antenna Input
a FM Antenna Input
£ Record Outputs: Each of these two pairs of
jacks carries the identical audio signal, which is the
audio output selected through the Record Outputs
menu (see figures OSD-35 and OSD-36 on pages 50 and
51). Connect these jacks to the "REC IN" input of a VCR,
cassette recorder, DAT, reel-to-reel recorder, or another
audio recording device.
¢ Main Channel Audio Outputs: Connect these
jacks to the input of the audio power amplifier. When
making connections to an amplifier make certain that
channels are connected to a matching input on the amp.
(e.g., front left to front left, center to center, etc.).
10
⁄ ‚
MODEL NO.: SIGNATURE SERIES 2.0
OUT
HARMAN KARDON
MAIN
NORTHRIDGE
CALIFORNIA, USA
MADE IN USA
~
115V 60Hz
75 WATTS
SERIAL NUMBER
REC C AU TI O N C AU T I O N
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS:
RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
WARNING:
TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK DO NOT EXPOSE THIS
IR TRIGGER
EQUIPMENT TO RAIN OR MOISTURE.
OUT OUTPUT
©
Confidential Unpublished Works 1992-1997 Dolby Laboratories.
All Rights reserved.
DTS and DTS Surround are trademarks of Digital Theater Systems.