Table of Contents
Advertisement
THE CERAMIC HOB
CAUTION: DO NOT USE THE APPLIANCE IF THE CERAMIC GLASS IS DAMAGED. IF A
FAULT OR CRACK BECOMES VISIBLE DURING COOKING, DISCONNECT THE
APPLIANCE IMMEDIATELY FROM THE ELECTRICITY SUPPLY AND CONTACT YOUR
LOCAL SERVICE FORCE CENTRE.
USING THE HOB
12.30
·
Turn the control knob in either direction to vary
the heat setting. The highest number represents
the hottest setting and the lowest number
represents the coolest setting. Choose a setting
appropriate to the quantity and type of food to be
cooked.
·
This model has the added feature of two Rapid
power zone hotplates which react more quickly
than the other ceramic hotplates and are easily
identified by their instant red glow.
RECOMMENDED SAUCEPANS
For speed and economy only good quality saucepans
with
flat
bases
and
recommended.
The saucepan base should be
approximately the same size as the cooking area, a
base diameter of up to 225mm (9") may be used on a
180mm (7") heated area.
close
fitting
lids
are
Ensure that new saucepans are well scrubbed to
remove edges and take off any deposits left from
manufacture.
Pressure cookers, preserving pans, etc., should
comply with the recommendations given above.
Traditional round bottomed Woks must not be used
even with a stand. Woks with flat-bottomed bases
are available and do comply with the above
recommendations.
NOTE
Occasionally the heated areas may be seen to switch
ON and OFF when higher heat settings are being
used. This is due to a safety device which prevents
the glass from overheating. Some switching ON and
OFF when cooking at high temperatures, e.g. deep
fat frying is quite normal, causes no damage to the
hob and little delay in cooking times.
Excessive switching may however be caused by the
use of an unsuitable saucepan or a saucepan which
is smaller than the heated area.
switching occurs, discontinue use of the saucepan.
16
If excessive
Advertisement
Table of Contents
