Table of Contents
Advertisement
3.
Position the hinge frame of the transparency adapter over the supporting posts
on the scanner so that the posts fit into the holes in the hinge frame.
4.
Gently slide the transparency adapter in such a way that the supporting posts
move into the narrowed slots adjacent to the holes.
5.
Insert the screws into the holes of the hinge frame and fasten them firmly.
6.
Plug the UTA (multi-pin D-SUB) end of the cable from the transparency
adapter into the UTA connector port on the back of your scanner.
Unlock the Optical Assembly of the UTA
1.
Find the Carriage Lock on the underside of the adapter near the rear.
2.
Insert a coin in the Carriage Lock. Turn it until it points to the unlocked mark.
Note: Before attempting to transport your scanner, it is important that you lock the
optical assembly in place to avoid any possible damage to the transparency
adapter's optical components. Insert a coin in the Carriage Lock. Turn it until
points to the lock mark.
5
Advertisement
Table of Contents
