Selecting The Mode Of The Remote - Sony RM-PP505L Operating Instructions Manual

To cancel programming
Press USE MODE during any step. The remote
automatically exits the macro setting mode.
To delay the output of an IR code
Start over from step 1. In step 3, press VIDEO
1, then MACRO1 or MACRO2. This allows
you to specify 1 second delay before output the
next IR code. Be sure not to press MACRO1 or
MACRO2 for more than 2 seconds.
To clear the programmed IR codes
Clear each macro step individually.
1
Press MACRO1 or MACRO2 (in which
the IR code you want to clear is
programmed) while pressing down USE
MODE.
2
Press the numeric button to select the
macro step number you want to clear.
3
Press VIDEO 1.
4
Hold down MACRO1 or MACRO2 for
more than 2 seconds.
The IR code is cleared. The indicator lights
twice slowly, then the remote automatically
exits the macro setting mode.
To start macro play
Press MACRO1 (or MACRO2).
Note
If the Macro Play function does not work properly,
program a delay between each operation. See "To
delay the output of an IR code".
Selecting the mode of the
remote
Set the remote mode using the USE MODE
button (wk) and the remote mode buttons (2).
Selecting the command mode
You can switch the command mode (AV1 or
AV2) of the remote. If the command mode of
the receiver and the remote is different, you
cannot use the remote to operate the receiver.
Press 1 (AV1) (or 2 (AV2)) while pressing
down USE MODE.
The indicator lights once (twice for AV2), then
the command mode switches.
Setting to the 2nd room mode.
You can use the remote to select the function
for the 2nd room (2nd room mode). You can
use the function buttons only for the 2nd room.
Press 2ND ROOM while pressing down
USE MODE.
The indicator lights for a while, then the mode
switches to the 2nd room mode.
Tips
• If you press a function button while pressing down
2ND ROOM, you can select the function for the
2nd room even though the mode is not set to the
2nd room mode.
• If you press 2ND ROOM only, you can output the
source signal of the current function of the receiver
to the amplifier in the 2nd room.
Setting to the 3rd room mode.
You can use the remote to select the function
for the 3rd room and adjust the volume in the
3rd room (3rd room mode). During 3rd room
mode, you can adjust the volume of speakers in
another room when you set the receiver to
output the sound using SPEAKER terminals.
You can use the function buttons and
MASTER VOL +/– buttons only.
Press 3 (3RD) while pressing down USE
MODE.
The indicator lights 3 times, then the mode
switches to the 3rd room mode.
To check the mode of the remote
Press USE MDOE. You can check the remote
by the indicator.
Mode Indicator lights
AV1 once
AV2 twice
2nd room once (for a while)
3rd room 3 times
15