Resetting Account - Sharp AR-5520N Operation Manual

USER SETTINGS

Resetting account

(program No.15)
The copy count of a single account or all accounts can
be reset to 0. If no account numbers have been
established, the error code "15E" will appear in the
display.
[Resetting all accounts]
Press the [1] key and then press the [START]
key ( ).
The copy counts of all accounts will be deleted.
[Resetting a single account]
1 Press the [0] key, and then press the
[START] key ( ).
2 Select the account number to be reset with
the [Copy ratio display] key (
then press the [START] key (
To reset another account number, enter the
Note
program number (15) for account number
deletion and then repeat the procedure for
"Resetting a single account".
76
Copying when "Auditing mode" is
enabled
When "Auditing mode" is enabled, "- - -" appears in the
display.
1
) and
).
2
3
Enter your 3-digit account number
with the numeric keys.
When you enter your account number, "0"
appears in the display to indicate that copying is
possible.
If you enter an incorrect number, press the
Note
[CLEAR] key (
number.
Follow the appropriate steps to make
the copy.
If you are performing an interrupt copy (p.28),
Note
be sure to press the [INTERRUPT] key (
when finished to exit interrupt mode.
When finished, press the [
( ).
ACC.#-C
If a misfeed occurs or the paper runs out
Note
during copying, your session will not end even
if the [ ] key (
ACC.#-C
) and then enter the correct
)
] key
) is pressed.