TeachLogic Titan neo Owner's Manual page 27

Danger
DO NOT ATTEMPT TO
CHARGE ALKALINE
BATTERIES
TRANSMITTER/MICROPHONES
UT-96HH Tranmitter Microphone Operation
Be sure the microphone is switched off before
1.
inserting batteries.
Remove lower identity cap.
2.
Remove lower battery compartment door.
3.
Insert two (2) AA batteries (use only alkaline
4.
or fully charged NiMH batteries).
Caution: Be sure to observe correct polarity
Replace lower battery compartment door.
5.
Locate power switch at base of microphone
6.
(small gray button)
Press upward and hold the power switch for 2-3
7.
seconds.
Power LED will illuminate "Red" and "On" will
8.
be displayed in the LCD screen.
LCD window will also display: Battery condition
9.
and CH #
A microphone sensitivity selection switch
10.
provides three modes of microphone sensitiv-
ity (HIGH, LOW, MUTE).
• MUTE: Mutes microphone "off" while
retaining transmission and RF connection.
• LOW: Use when microphone is held close
to mouth or strong vocal input.
• HIGH: Use when additional sensitivity is
required for softer voice.
LCD screen displays the channel number
11.
selected for the microphone. To display chan-
nel frequency: Press and hold the UP or DOWN
select button.
To change channel selection
12.
• Press and hold frequency SET button for
2 seconds. LCD panel will commence
flashing (indicating programming mode)
• Press UP or DOWN arrow to select channel
desired
• Press SET button to lock in channel
selected
Owner's Manual
27