Speaker Connection - Sharp CD-E110H Operation Manual

! Speaker connection

Connect the black wire to the minus (-) terminal, and the red wire to
the plus (+) terminal.
Caution:
" Use speakers with an impedance of 8 ohms
or more, as lower impedance speakers can
damage the unit.
" Do not mistake the right and the left chan-
nels. The right speaker is the one on the right
side when you face the unit.
" Do not let the bare speaker wires touch
each other.
" Do not allow any objects to fall into or to be
placed in the bass reflex ducts.
" Do not stand or sit on the speakers. You may
be injured.
Note:
The speaker grilles are not removable.
! Connecting the AC power lead
After checking all the connections have been made correctly, con-
nect the AC power lead to the AC power input socket, then plug the
AC power lead of this unit into the wall socket. If you plug in the unit
first, the unit will enter the demonstration mode.
Notes:
" Unplug the AC power lead from the wall socket if the unit will not
be in use for a prolonged period of time.
" Never use a power lead other than the one supplied. Otherwise,
a malfunction or an accident may occur.
! Demonstration mode
The first time the unit is plugged in, the
unit will enter the demonstration mode.
You will see words scroll.
To cancel the demonstration mode:
When the unit is in the power stand-by mode (demonstration mode),
press the EQUALIZER/X-BASS/DEMO button. The unit will enter
the low power consumption mode.
To return to the demonstration mode:
When the unit is in the power stand-by mode, press the EQUAL-
IZER/X-BASS/DEMO button again.
Note:
Incorrect
When the power is on, the EQUALIZER/X-BASS/DEMO button can
be used to select the pre-programmed equaliser and extra bass
modes.
! To turn the power on
Press the ON/STAND-BY button to turn the power on.
After use:
Press the ON/STAND-BY button to enter the power stand-by
mode.
03/1/21 CD-E110H(H)E1.fm
CD-E110H
ENGLISH
8
E-8