Table of Contents
Advertisement
Watching TV (Analogue)
Simple button operations for
changing channels
You can change channels in several ways.
Using Pr/son the remote control unit
• Press Pr to increase channel number.
• Press Ps to decrease channel number.
NOTE
• Pr/s on the Display operates the same as Pr/son
the remote control unit.
• In TV input mode, you cannot change the DTV input mode
channel, and vice versa.
Using 0 – 9 on the remote control unit
Select the channels directly by pressing buttons 0 to
9.
a
To select a 1-digit channel (e.g. channel 2):
• Press the 2 button.
To select a 2-digit channel (e.g. channel 12):
• Press 1, followed by 2.
• When you enter the channel, a 3-digit input underbar
appears in digital TV mode and a 2-digit in analogue
TV mode.
Once you input a channel it is set after a few
moments if there are no other operations. Or press
OK to set immediately after input.
• Complete this procedure within 3 seconds, otherwise the
selection will not be made on the 2-digit channel mode.
When viewing Teletext information
View a page directly which is 3-digit page number from
100 to 899 by pressing buttons 0 to 9.
Channel display
Channel display changes approximately after 3
seconds as shown below.
(Example)
Using Flashback (A) on the remote
control unit
Pr/s
Press A to switch the currently tuned channel to the
previously tuned channel.
Press A again to switch back to the currently tuned
channel.
Press A to toggle between the currently selected input
source and the previously selected one.
Press A to return to the previous page in TELETEXT
mode.
NOTE
SAT.1
12
PAL
B/G
SAT.1
12
MONO
19
Advertisement
Table of Contents
