Table of Contents
Advertisement
Watching TV
Simple button operations for
changing channels
You can change channels in several ways.
Using CHr/son the remote control unit
• Press CHr to increase channel number.
• Press CHs to decrease channel number.
NOTE
• CHs/r on the TV operates the same as CHs/ron
the remote control unit.
Using 0 – 9 on the remote control unit
Select the channels directly by pressing buttons 0 to
9.
a
To select a 1-digit channel (e.g. channel 2):
• Press 2. If
is indicated and the picture does not
"2"
change immediately, press o to switch over to the
1-digit select mode and press 2 again.
To select a 2-digit channel (e.g. channel 12):
• Press o to set the 2-digit select mode. Press 1,
followed by 2.
NOTE
• Complete this procedure within 3 seconds, otherwise the
selection will not be made on the 2-digit channel mode.
When viewing Teletext information
View a page directly which is 3-digit page number from
100 to 899 by pressing buttons 0 to 9.
Channel display
Channel display changes approximately after 3
seconds as shown below.
(Example)
Using Flashback (A) on the remote
control unit
Press A to switch the currently tuned channel to the
previously tuned channel.
Press A again to switch back to the currently tuned
channel.
Press A to toggle between the currently selected input
source and the previously selected one.
Press A to return to the previous page in TELETEXT
mode.
SAT.1
12
PAL
B/G
SAT.1
12
MONO
15
Advertisement
Table of Contents
