Table of Contents
Advertisement
Place handset
into base
Menu
Handset is
registering
ë
Ð
INT
Menu
If you have purchased a model with multiple handsets, repeat the registration
process for each handset. Handsets are assigned the lowest available internal
number (1-4). If more than one handset is registered to the base station the internal
handset number appears on the display, e.g. INT 2. If the internal numbers 1–4 are
already assigned to other devices, the number 4 will be overwritten.
Please note
u
Each key press interrupts the automatic registration.
u
If automatic registration does not work, the handset will have to be
registered manually (
To charge the batteries, leave the handset in the charging cradle.
Please note
Only place the handset in the base station or charging cradle that is intended
for it.
Should you have any questions and problems
Before you can use the phone, you must first
register the handset to the base station.
¤
Place the handset with the display facing
up in the base station.
The handset registers automatically.
Registration can take up to 5 minutes.
Do not remove the handset from the
base station during this time.
V
The following is displayed after successful reg-
istration:
u
the strength of the reception signal
between base station and handset:
– good to poor: Ð i Ñ Ò
– no reception: | flashes
u
battery charge status:
– = e V U (flat to full)
– = flashes: batteries almost flat
– e V U flashes: charging proce-
¢
page 30).
dure
¢
page 37.
First steps
9
Advertisement
Table of Contents
