Table of Contents
Advertisement
Closing the battery cover
¤
Hold the battery cover at a slight angle
and introduce the two lower lugs into
the casing first. Then close the cover so
that it clicks into place.
Locking the battery cover
Insert the catches on the lock ring or belt
clip into the notches in the casing and
make sure that the arrow markings on the
casing are facing those on the bottom of
the ring. Turn the lock ring or belt clip
clockwise to the end stop. When both
holes are horizontally aligned with the
upper edge of the handset the lock ring is
closed.
Opening the battery cover
Position both thumbs on the lock ring and
at the same time turn the lock ring or belt
clip anticlockwise and remove.
¤
Insert a coin into the cavity at the top of
the battery cover and twist it until the
cover opens.
Placing the handset in the charging
cradle
¤
Plug the charging cradle mains adapter
into a mains power socket.
¤
Place the handset in the charger with
the display facing forward.
The handset is already registered with the
base station at the factory.
the display. You do not have to re-register.
If, nonetheless, you have to register your
handset with the base station, please see
page 31.
Leave the handset in the charging cradle
to charge the battery pack.
Notes:
– If the handset has switched itself off
because the battery pack is flat and is then
placed in the charging cradle, it will switch
itself on automatically.
– The handset must only be placed in the
designated charging cradle.
For questions and problems see page 41.
First Steps
INT 1
appears in
7
Advertisement
Table of Contents
