Connections Menu; Decoder; Input Select; Hdmi Setup - Sharp AQUOS LC-37XD10E Operation Manual

Menu operations

Connections menu

TV menu
Connections

Decoder

EXT 2

Input select

HDMI setup

Supply voltage no (0V)
AV-Link
Miscellaneous
Decoder
Make sure to select the terminal (EXT 1 or 2) to which
the decoder is connected.
NOTE
• This setting will be refl ected in the "Decoder stations"
function under "Miscellaneous". (Page 16)
Input select
For setting the signal type of external equipment.
Input source
EXT 1 Y/C, CVBS, RGB
EXT 2 Y/C, CVBS
EXT 4 PC (RGB), COMPONENT
NOTE
• If no (colour) image displays, try to change the other
signal type.
• Check the operation manual of the external equipment for
the signal type.
• TV, DTV, EXT3, EXT5 and EXT6 are not displayed in Input
Select.
• If both CVBS and RGB signals are input to EXT 1 using
a SCART cable, the TV may output an RGB signal even
though you have designated CVBS for the respective
terminal. This happens due to the setting of your external
equipment.
Setup
Signal type
HDMI setup
HDMI (High-Defi nition Multimedia Interface) terminal
selection.
1
Press MENU and the TV menu screen displays.
2 Press c / d to select "Connections", and then
press OK.
3 Press a / b to select "HDMI setup", and then
press OK.
4 Press a / b to select "EXT5" or "EXT6", and
then press OK.
5 Press a / b to select the desired item.
6 Press c / d to select the desired setting.
HDMI setup Selectable
items items
Signal type* RGB/YCbCr
4:4:4/YCbCr 4:2:2
Colour ITU601/ITU709
matrix*
Dynamic Normal/
range* Enhanced
Auto view Enable/Disable
Audio Digital/Analogue
select**
NOTE
• Refer to your external equipment operation manual for the
signal type.
• Items with * may be greyed out depending on the type of
signal input from the external equipment.
• Item marked ** is only available when EXT5 is selected.
Description
Select the video signal type
from the HDMI terminal.
Select the internal colour
space conversion method
when an RGB signal is
input.
Select the signal amplitude
range. Usually, select
"Normal".
Set whether or not to use
Wide mode based on
signal recognition, including
an HDMI signal.
Select "Digital" for audio
signal via the HDMI
terminal. Select "Analogue"
for audio signal via the
AUDIO jack.
15