To Replace The Mains Plug; Installation - Sharp R-3731 Operation Manual

R-3731 English 21/07/2004
The wires in the mains cable are colour coded as
shown opposite:
As the colours of the cores in the mains lead of your
oven may not correspond with the coloured marking
identifying the terminals in your plug, connect the
wires as described below:
Make sure the terminal screws are tight and the cable
is held securely by the cable grip where it enters the
plug. Like most appliances in your home, your oven
must be connected to a single phase 230-240 Volt,
50Hz alternating current supply.
If you do not make the proper electrical connections
you might damage the oven or injure yourself. Neither
SHARP nor the supplier will be liable if this happens.
1. Remove all packing materials from the inside of
the oven cavity. Discard the loose polythene
sheet from between the door and cavity. Remove
the feature sticker, if attached, from the outside of
the door.
Remove this film.
2. Check the oven carefully for any signs of damage.
3. Place the oven on a flat, level surface strong
enough to support the oven's weight plus the
heaviest item likely to be cooked.
12:40 Page 7

TO REPLACE THE MAINS PLUG

7
green and yellow stripes =
blue =
brown =
• The green and yellow wire to the plug terminal
marked E or or coloured green or coloured
green and yellow.
• The blue wire to the plug terminal marked N or
coloured black or coloured blue.
• The brown wire to the plug terminal marked L or
coloured red or coloured brown.
THIS APPLIANCE MUST BE EARTHED.
IF YOU HAVE ANY DOUBTS ABOUT YOUR
ELECTRICAL SUPPLY ASK A QUALIFIED
ELECTRICIAN.

INSTALLATION

4. Ensure there is a minimum of free space
above the oven of 19 cm.
5. Do not stack this oven.
6. Securely connect the plug of the oven to a
standard ear thed (grounded) household
electrical outlet.
EARTH
NEUTRAL
LIVE
19 cm