Before Operation; Cooking With Pre-Programmed Memories - Sharp R-3730 Operation Manual

R-3730 English 22/06/2001
LOCK FUNCTION
• Your oven has a lock function and is locked when
you first connect to an electrical socket. At that time
the digital display will show:
• The lock will be set when the oven is plugged
in, and you can use all functions except for
the MEMORY key.
• To release the lock function, press the
MANUAL key and hold for 2 seconds until the
audible sound is heard. LOCK indicator will
disappear and you can use the MEMORY key.
To lock the oven press the MANUAL key and
hold for 2 seconds.
• Your oven is already installed with 30 cooking
programmes for apetito products in each number
key. The first 20 programmes cannot be changed.
• The input is cancelled when any keys are not
pressed for more than 3 minutes.

COOKING WITH PRE-PROGRAMMED MEMORIES

• The oven has 30 memory banks (1 - 30). The
programme numbers of memory are made
especially for deep-frozen menus of apetito.
• The total cooking times for each memory bank are
shown in the table on page 8. The memory banks
21 - 30 can be changed individually if required
(see page 14).
• In addition for all memory banks a reduce factor is
stored. When you prefer a little under finish, it is
recommended to use the REDUCE function..
10:20 AM Page 7
7

BEFORE OPERATION

SOUND SETTING
• If you wish the oven to operate with no sound,
press the MANUAL key and then the SOUND
key once. When you hear the signal your oven will
operate without sound. To restore sound, press the
MANUAL key and then the SOUND key again
and the signal will sound twice.
STOPPING THE OVEN
• will appear on the display after the time
reaches zero (e.g. at the end of the cooking
time). If you press the STOP key twice during
cooking, appears in the display.
• If you wish to stop the oven during cooking:
Press the STOP key once or open the door.
To start the oven again, close the door and press
the START key within 1 minute.
• If you wish to cancel a programme during cooking,
press the STOP key twice.
• If you wish to erase a mistake during
programming, press STOP key once.
The reduce factor is separatly made for each
programme.
The stored reduce factor for 21 - 30 can also be
changed individually if required (see page 15).
• Information in these memory banks is not lost
during power interruptions. If the power goes off,
the oven does not need to be re-programmed.
Batteries are not necessary for this type of memory.
• To check the stored programmes or reduce factors
refer to "memory check" on page 16.
STOP