Fig. 13
Lasered hinge pin
pivoting point
Up and down clearance
adjustment slots.
How to Reduce the Weight for Installation, cont'd
2. Remove the door by swinging it open approximately
o
90
and lift it upward until it clears the hinge pins.
3. Remove the ash pan
4. Remove the (4) internal pieces of cast iron. See Fig.
14 and 15.
Installation
•
Lift up on the 2 bottom corners of the medallion until
it is higher than the top of the flame guide.
•
Pull the bottom edge of the medallion front approxi-
mately 1 inch.
•
Pull downward on the corners of the medallion until
the top is released from the 2 retainers that keep the
top aligned when in place.
•
Note: The heat exchanger covers will tilt to the front
when the center medallion is
12", but the left side tube requires the total length of the
brush to be used.
Cast side
panel hinge
• Remove the heat exchanger cover by lifting it upward
about 1/2 inch and move the bottom edge front until it
sits flat on the firebox bottom.
• Rotate the edge of the heat exchanger closest to the
burnpot until it is in front of the burnpot.
• Tip the top of the heat exchanger toward the middle of
the opening until it can be lifted up and out.
Lifting tab
Fig. 15
Removing the Center Medallion
Center Medallion
1
st
:UP
1
st
:UP
Flame guide
Burn Pot
Fig. 14
Removing the Heat Exchanger Covers
10
removed.pproximatlely
3
rd
: DOWN
rd
3
: DOWN
nd
2
2
nd
: OUT
: OUT