Harman Stove Company Accentra The Harman Accentra Pellet Insert Installation And Operating Manual page 28

Fig.58
Fig. 59
Fig. 60
Viewed from below through the ash pan opening.
Maintenance - Burn Pot
Burn Pot Cleaning and Maintenance
1. Scrape the top holed surface and sides of the
burn pot down to auger tube.(Fig 58) It is not
necessary to completely remove all material from
the burn pot. The excess will be pushed out during
the next use.
2. Loosen the (2) wing thumb screws on the lower
front angle of the burn pot. (Fig. 59)
3. Lift off the clean-out cover (Fig.59) to open the
bottom clean-out chamber. (Fig.60)
4. Clean ash buildup from inside the chamber while
cover is off. Use the scraper to tap on the top front
edge of the burn pot. This will help knock pieces of
ash, loosened by the scraping process, down
through the holes. It also helps knock scale off of
the igniter element.
Figure 60
service by insulated male/female wire connectors.
These connections between the hot leads (the
wires inside the burn pot) and the cold leads (the
wires from the control board) are always pulled to
the inside rear of the feeder body. (Not coiled
inside the burn pot.)
are to the inside rear of the feeder body. Also, the
extra wire of the igniter wire service loop must be
pulled out through the rear of the feeder and tied
up so that it will not be damaged by any moving
parts.
Burn pot igniter
Igniter hot lead wires
(high temperature)
DANGER
Disconnect the power to the unit before
removing cover.
The igniter is made to be removable for
It is very important that these connections
DANGER
Disconnect the power to the unit before
removing cover.
WARNING
Use caution when cleaning burn pot clean-
out chamber. Do not damage the high
temperature igniter wires.
Note: The hot lead/cold lead connection
must always be pulled to the rear of the
feeder body before operation.
29