Anti-Theft System - Panasonic CQ-FX323W Operating Instructions Manual

Installation
E (continued)
N
G
L
I To Remove the Unit
S
q
H
Remove the removable
face plate.
13
q Press [OPEN] . The Open
removable face plate
will be opened.
w Push the face plate to
either the right or left.
OPEN
e Pull it out toward you.
LEVEL
w
Remove the trim plate u with a screwdriver.
e
Pull out the unit while pushing down the lock
lever with a screwdriver.
r
Remove the unit pulling with both hands.
Cautions:
¡Do not touch the contacts on the face plate or on the main unit, since this may result in poor electrical contacts.
¡If dirt or other foreign substances get on the contacts, wipe them off with clean and dry cloth.
¡Do not apply a strong downward force onto the face plate and do not put anything on it while it is open, or it might be
damaged.
18
CQ-FX323W
CQ-FX323W
Contact
q Open w Push
e Pull out
uTrim Plate
Screwdriver
1
2
Lock Lever
Screwdriver

Anti-Theft System

This unit is equipped with a removable face plate. Removing
this face plate makes the radio totally inoperable.
Place Removable Face Plate
into Case
q Switch off the power of the unit.
w Remove the removable face plate.
(a Page 18)
e Gently press the bottom of the case and open the cover.
Place the face plate into the case and take it with you
when you leave the car.
Cautions:
¡This face plate is not water-proof. Do not expose it to water or excessive moisture.
¡Do not remove the face plate while driving your car.
¡Do not place the face plate on the dashboard or nearby areas where the temperature rises to high levels.
Install Removable Face Plate
q Fit the face plate with its right or left hole on one of the
pins provided on the main unit.
w Fit the other hole on the other pin applying slight pres-
sure.
e Move the face plate up and down a few times to make
sure it is secure. Then close the front panel and press
down the right side of the face plate until it clicks into
place.
Security Indicator
The security indicator blinks when the removable face plate
is removed from the unit.
Press and hold [SEL] for more than 2seconds when the
power is on. "LED On" is displayed,and the security indicator
turns on. (Default: LED On)
Display Security Indicator
Blinks
OFF
Removable Face Plate Case
Security Indicator
Caution: When you want to remove the unit,the
security indicator functions can be canceled by follow-
ing procedure.
¡Install the removable face plate.
¡Disconnect the power connector for more than 3
minutes and then reconnect it.
CQ-FX323W
E
N
G
L
I
S
H
14 1
19