Table of Contents
Advertisement
Installation
E
N
G
L
I
Preparation
S
H
¡Before installation, check the radio operation with antenna
11
and speakers.
¡Disconnect the cable from the negative (–) battery terminal
(see caution below).
¡Unit should be installed in a horizontal position with the front
end up at a convenient angle, but not more than 30°.
30° or less
Caution: Do not disconnect the battery terminals of a car
with trip or navigational computer since all user settings
stored in memory will be lost. Instead take extra care with
installing the unit to prevent shorts.
Dashboard Installation
Installation Opening
The unit can be installed in
182 mm
any dashboard having an
opening as shown at right.
The dashboard should be
4.5 mm - 6 mm thick in order to be able to support the unit.
Installation Precautions
This product should be installed by a professional installer, if
possible.
In case of difficulty, please consult your shop when you pur-
chased this unit.
1. This system is to be used only in a 12-volt, DC battery sys-
tem (car) with negative ground.
2. Follow the electrical connections carefully
(a
Failure to do so may result in damage to the unit.
3. Connect the power lead (red) after all other connections are
made.
4. Be sure to connect the battery lead (yellow) to the positive
terminal (+) of the battery or fuse block (BAT) terminal.
5. Insulate all exposed wires to prevent short circuiting.
6. Secure all loose wires after installing the unit.
7. Please carefully read the operating and installation instruc-
tions of the respective equipment before connecting it to this
unit.
16
CQ-FX323W
CQ-FX323W
Supplied Hardware
No.
Item
q
Mounting Collar
w
Mounting Bolt (5 mmø)
Tapping Screw
e
(5 mmø x 16 mm)
r
Rear Support Strap
t
Hex. Nut (5 mmø)
y
Power Connector
u
Trim Plate
(a) Using the Rear Support Strap
53 mm
Fire Wall of the Car
3 mmø
eTapping Screw
tHex. Nut
rRear Support Strap
wMounting Bolt
qMounting Collar
Page 20).
(b) Using the Rubber Cushion (Option)
Rear Support Bracket
(Provided on the car)
Rubber Cushion
(Option)
wMounting Bolt
qMounting Collar
Cautions:
¡We strongly recommend that you wear gloves for installation work to protect yourself from injuries.
Diagram
Q'ty
¡When bending the mounting tab of the mounting collar with a screwdriver, be careful not to injure your hands and
fingers.
1
First complete the electrical connections, and
then check them for
1
The included Mounting Collar q q is
designed specially for this unit .
Do not use it to attach any other models.
1
1
1
1
1
Lock Lever (C)
Power Connector y
Make sure that the lock lever
(C) is flush with the mounting
collar (not projecting outward).
Insert Mounting Collar q into the
1
correctness.(a
Page 20)
dashboard, and bend the mounting
tabs out with a screwdriver.
Mounting Tabs
Mounting Bolt w
Establish the rear connections of the
2
unit.
After fixing Mounting Bolt w and Power
Connector y , Establish the rear connections of
the unit to the car body by either method (a) or (b)
shown on the previous page.
3
Insert Trim Plate u.
After installation reconnect the
4
negative (–) battery terminal.
Lock Lever
E
N
G
L
I
S
H
12
1
17
CQ-FX323W
Advertisement
Table of Contents
