Function Setting - Panasonic CQ-C3355N Operating Instructions Manual

Function Setting

1
Hold down [VOL]
(PUSH SEL: Select) for
2 sec. or more to open
the menu.
2
Press [VOL] (PUSH SEL: Select) to
select a mode to be adjusted.
3
Turn [VOL] clockwise
or counterclockwise to
adjust.
Notes:
• The sequence and contents of setting items may
depend on the conditions of devices to be connected.
For further information, refer to the System Upgrade
Guidebook or the instruction manuals for the devices
to be connected.
• To return to the regular mode, press [DISP].
• If no operation takes place for more than 5 seconds
in function setting, the display returns to the regular
mode.
FM Monaural Reception (FM Mode)
Noise is signifi cantly decreased when weak signals are
received from an FM broadcast station.
 : MONO ON
 : MONO OFF (Default)
Local Tuning (Radio Mode)
Only stations with good reception are detected in seek
tuning.
 : LOCAL ON
 : LOCAL OFF (Default)
28
CQ-C3355N
Region (REG) Mode (FM Mode)
You can change the selection range of AF, Best Station
Research and PI seek.
 : The frequency
is changed only for
programs within the
region.
 : The frequency
is changed also for
programs outside the
region. (Default)
Note: When the REG mode is switched from OFF to ON
or vice versa, the AF mode turns on automatically.
PTY Language Selection (RDS Mode)
 : English (Default)
 : Swedish
Demonstration
You can set up the monitor to display or hide the
demonstration screen.
 : On (Default)
 : Off
Note: Button operation with either the main unit or
remote control allows users to cancel the demonstration
screen for 20 seconds and enable the selected operation
even in the demo-on mode.
Level Meter Display Patterns (PATTERN)
Variety: 4 types, OFF
: Off
: Pattern 1 (Default)
: Pattern 2
: Pattern 3
: Pattern 4
Mute/Attenuation
You can select mute or attenuation.
 : Volume down by 10
steps
 : Volume off (Default)
External Mute
You can mute the current source with Panasonic
navigation system provides voice guidance or car
telephone conversation is in progress.
(Setting range: 0 to 2, OFF)
LV0: No sound (Default)
LV1: 15 steps decrease
LV2: 10 steps decrease
OFF : Unchanged
When External Mute is
activated
(Example: MUTE LV0)
AUX1 Skip
If AUX1 is not used, the AUX1 mode is skipped when
selecting the source.
 : On (Skip disabled.)
(Default)
 : Off (Skip enabled.)
ACC Selection
ACC ON:
• The power is turned on automatically when inserting a
disc.
• The clock can be displayed even if the power is off.
 : Set to ON if your car
has an ACC position.
 : Set to OFF if your
car has no ACC
position. (Default)
Caution
• Be sure to select OFF when your car has
no ACC position in the ignition switch.
Failure to do this could cause the battery
to go dead.
29
CQ-C3355N