Related Manuals for Aiwa CD-CX2250
Summary of Contents for Aiwa CD-CX2250
- Page 1 CDC-X2250 OPERATING INSTRUCTIONS MANUAL DE INSTRUCCIONES MANUAL DE INSTRUÇÕES STEREO CAR CD RECEIVER RADIO-TOCADISCOS DE CD ESTEREOFONICO PARA AUTOMOVIL ENGLISH ESPAÑOL PORTUGUÊS 8C-KCG-920-01 020430ATM-OS...
-
Page 2: Table Of Contents
PRECAUTIONS TABLE OF CONTENTS • Use only in a 12-volt DC negative-ground electrical THEFT PROTECTION ..........2 system. BASIC OPERATION, AUDIO AND CLOCK • Disconnect the vehicle’s negative battery terminal ADJUSTMENT ............. 2 while mounting and connecting the unit. RADIO OPERATION ..........3 •... -
Page 3: Theft Protection
THEFT PROTECTION BASIC OPERATION, AUDIO AND CLOCK Take the front panel with you when leaving the car, and keep it in the supplied carrying case. ADJUSTMENT Detaching the front panel PWR/MUTE Before detaching the front panel, remove the CD to AUDIO CONTROL prevent possible damage to the unit. -
Page 4: Radio Operation
Adjusting sound Setting the clock You can select the following modes for adjusting sound Press and hold DISP until the clock indicator depending on the music you listen to: BASS (low flashes in the display. frequencies), TRE (high frequencies), BAL (left/right), Press i (to set hour) or k (to set minute), and FAD (front/ rear) and H-BASS (high bass). -
Page 5: Cd Player Operation
Presetting stations manually Monaural mode When FM signals become weak, or FM reception (Manual Memory) becomes poor, the unit automatically switches to Press BAND repeatedly to select the desired band Monaural mode to reduce noise. (FM1, FM2, FM3, AM1, or AM2). Local mode Press i or k to tune in to a desired station (see Local mode allows you to tune in only to strong stations... -
Page 6: Auxiliary Equipment
Intro Play Labeled-side up You can locate a desired track by monitoring the first 10 seconds of all the tracks on a CD. Press INT during CD play. “SCAN” appears in the display. Press INT again when the desired track is played. The unit returns to normal CD play. -
Page 7: Other Functions
OTHER FUNCTIONS INSTALLATION AND CONNECTIONS OF SPEAKERS Supplied mounting hardware for installation The letters are keyed to those in the instructions. AUDIO CONTROL a Speaker cord × 2 b Screw (4 × 25 mm) × 8 Changing the key illumination color You can choose blue or red as the key illumination color. -
Page 8: Troubleshooting
Installation Basically this speaker system is designed to be mounted on the rear deck. Gray&blue Gray&red When there is no dedicated hole on the rear deck, or, if any, it does not fit the speaker, please make fitted Gray Gray holes by cutting the rear deck. -
Page 9: Maintenance
MAINTENANCE GENERAL Power-Supply Voltage: 14.4 V (11 to 16 V allowable), DC, negative ground Cleaning the front panel Load Impedance: 4 Ω Wipe the surface with a soft, dry cloth. Do not use liquid Tone Control: cleaners or aerosol cleaners. Bass ±...