Table of Contents
Advertisement
WARnInG: Maximum cylinder height is 1 feet 7 inches (0.5m). Maximum cyl-
inder weight is 22 lb., including gas. nEVER exceed either of these maximums.
1.
CAUtIOn!
shielding gas. To use CO
regulator/flow meter (neither one included).
2.
Thread the provided strap through the slots on the back of the welder. With
assistance, set the cylinder onto the shelf at the back of the welder.
3.
Secure the cylinder in place with the strap.
4.
Remove the protective cap from the cylinder. Stand to the side of the cylinder
valve, and open the valve slightly to blow dust and dirt from the valve. Then, close
the valve.
5.
Make sure the Flow Adjust on the Pressure Regulator/Flow Meter is turned off.
Then, screw the Pressure Regulator/Flow Meter (not included) firmly onto the
cylinder valve.
6.
Attach the Gas Line (41) to the Pressure Regulator/Flow Meter from the Gas Inlet
located on the Back Panel (6) of the Welder.
7.
Adjust the flow rate of the gas by turning the Flow Adjust. The typical flow rate
is 10-30 CFH (cubic feet per hour). Make sure to check the Welding Wire
manufacturer's recommended flow rate.
While the Gas Cylinder is attached, this unit must only
be transported using an appropriate welding cart (not
included).
transporting this welder any other way could result in the
cylinder being damaged or ruptured, causing an explosion
and, potentially, SEVERE pERSOnAL InJURY.
For technical questions, please call 1-800-444-3353;
SKU 94164
tO InStALL A GAS CYLInDER
Do not use an Argon/Mixed pressure regulator/flow meter with CO
shielding gas, you must install a CO
2
RISK OF ExpLOSIOn!
troubleshooting section at end of manual.
WARnInG
2
gas pressure
2
Page 16
Hide quick links:
Advertisement
Table of Contents
