SEttInG thE GUn pOLARItY FOR WIRE tYpE
1.
Set for Electrode Negative (DCEN) for
(E to C), positive ground (D to A). SHOWN IN FIGURE H, INITIAL SETUP.
2.
Set for Electrode Positive (DCEP) for
electrode (E to A), negative ground (D to C).
Connections the opposite of Figure H.
3.
When connecting to the weld output terminals, do not
place anything between the welding Cable Terminals
(A and C) and their copper connections.
4.
Always read and follow wire manufacturer's
recommended polarity.
5.
KEY:
A.
positive (+) Output terminal
B.
polarity Changeover Label
C.
negative (–) Output terminal
D.
Ground Cable
E.
Electrode Cable
For technical questions, please call 1-800-444-3353;
SKU 94164
troubleshooting section at end of manual.
gasless flux core wire. Negative electrode
gas welding with solid-core wire. Positive
C
E
B
D
A
FIGURE h
REV 09a
Page 15